• Skip to primary navigation
  • Skip to main content
  • Skip to primary sidebar

Circuit Ideas for You

Get free circuit ideas online.

  • Home
  • Privacy Policy
  • About

LED and Lamps

Home » LED and Lamps » Page 2

Battery Operated Automatic Emergency Light Circuit

Last updated on 10 August 2025 by Admin-Lavi Leave a Comment

Automatic emergency light use battery and give light when power is gone. Lamp turns ON itself when main power fails and is good for home, office or anywhere which need extra light. It is best to use 6V lead acid battery or 5×1.2V NiCd cells. The design for Battery Operated Automatic Emergency Light Circuit is […]

Filed Under: Battery Charger Circuits, LED and Lamps

Simple Relay Based Lamp Flasher Circuit

Last updated on 10 August 2025 by Admin-Lavi Leave a Comment

Simple Relay Based Lamp Flasher Circuit is good for indicators, warning lights and in anything that need attention. Circuit uses relay, resistor, capacitor to blink light and does not need any complex parts. It runs on 12V and is easy for beginners to learn electronics. Circuit Working: Parts List: Component Specification Quantity Resistor 220Ω 1W […]

Filed Under: LED and Lamps

Simple 12V Lamp Flasher Circuit using IC LM317

Last updated on 10 August 2025 by Admin-Lavi Leave a Comment

This Simple 12V Lamp Flasher Circuit using IC LM317 is a cool project to make 12V lamp blink. This circuit is not only for indicator or warning light but also for car or decoration light. IC LM317 usually controls the voltage but here it work like oscillator for blink. It can handle 1A, so lamp […]

Filed Under: LED and Lamps

Emergency Lamp Circuit using IC LM358

Last updated on 10 August 2025 by Admin-Lavi Leave a Comment

Simple but strong Emergency Lamp Circuit using IC LM358 is an easy to make project. Circuit is good for backup light when power goes OFF. Circuit gives automatic light during power cut. IC LM358 op-amp sense power fail and control the lamp. It needs 12V battery to run the circuit. Circuit Working: Parts List: Component […]

Filed Under: LED and Lamps

Simple 24V Lamp Flasher Circuit using Transistors

Last updated on 10 August 2025 by Admin-Lavi Leave a Comment

Simple 24V Lamp Flasher Circuit using Transistors makes 24V lamps blink back and forth with non stop. It uses transistors to turn two lamps ON and OFF one by one like astable multivibrator. This circuit is good for signal use like warning or decoration lights with steady blink. We must use 24V DC power to […]

Filed Under: LED and Lamps, Transistor Circuits

Simple AC Mains Powered LED Night Light Circuit

Last updated on 9 August 2025 by Admin-Lavi Leave a Comment

This is Simple AC Mains Powered LED Night Light Circuit which runs on AC mains power 230V. With no big transformer needed. It can light 24 bright white LEDs with each takes 50mA current. It is small, cheap and good for night room light. Circuit uses capacitor power supply, bridge rectifier and filter capacitor to […]

Filed Under: LED and Lamps, Power Supply Circuits

  • « Go to Previous Page
  • Page 1
  • Page 2
  • Page 3
  • Page 4
  • Interim pages omitted …
  • Page 19
  • Go to Next Page »

Primary Sidebar




Categories

  • Alarm Circuits (31)
  • Amplifier Circuits (67)
  • Arduino Projects (30)
  • Audio Circuits (93)
  • Automobile Circuits (19)
  • Battery Charger Circuits (48)
  • Free Energy (13)
  • Heater and Temperature Controllers (9)
  • High Voltage (1)
  • Indicator Circuits (38)
  • Inverter Circuits (13)
  • LDR Circuits (14)
  • LED and Lamps (113)
  • Meters and Testers (27)
  • Motor Controllers (18)
  • Oscillator Circuits (32)
  • Power Supply Circuits (91)
  • Remote Control Circuits (6)
  • Security and Protection (23)
  • Sensors and Detectors (74)
  • Solar Circuits (16)
  • Timer Circuits (28)
  • Transistor Circuits (56)
  • Transmitter Circuit (12)
  • Tutorials (4)
  • Water Level Controller (4)

Copyright © 2025 | New Circuit Ideas