There are few protection circuit which we have shown in our previous post, but this article is for Simple 12V Protection and Soft Start Circuit for 12V systems. It helps to protect our load from sudden high current and voltage spikes and also, it gives a smooth start when power turns ON, because of this, […]
LM350 Based 24V 3A Voltage Regulator Circuit
This project shows about an easy and simple LM350 Based 24V 3A Voltage Regulator Circuit. The circuit converts AC mains into stable DC output, and also this design suits small lab use, battery charging and general electronics work. Moreover, LM350 gives adjustable output with good current capability, therefore by adjusting potentiometer we can get around […]
24V 2A Zener Transistor Voltage Regulator Circuit
This article explain us about a simple 24V 2A Zener Transistor Voltage Regulator Circuit, which converts 230V AC into stable 24V DC output. Moreover, this circuit uses step down transformer, rectifier diodes, filter capacitors, Zener reference and power transistor. Also, this circuit gives good voltage stability even when load changes, because of this output voltage […]
Simple 24V 1A DC Power Supply Circuit using 7824 IC
In this tutorial, we will talk about Simple 24V 1A DC Power Supply Circuit using 7824 IC, which convert AC voltage into stable DC output and gives around 1A current. Also, many electronic circuits need fixed 24V supply, so this circuit is very useful, as it give clean and steady voltage with low ripple. This […]
DC Voltage Splitter Circuit with Op-Amp and Transistor Buffer
In my previous post I already made a Simple Voltage Splitter Circuit using uA741 Op-Amp, but this time I added transistors so circuit can handle more current and work more strong. This DC voltage splitter circuit with op-amp and transistor buffer change single DC supply into dual supply like +V and –V with one virtual […]
Simple Adjustable 5V to 12V Voltage Regulator Circuit using Transistors
This post is for Simple Adjustable 5V to 12V Voltage Regulator Circuit using TIP31 which uses transformer, bridge rectifier, filter capacitor and transistor control stage. The circuit can give output voltage from about 5V to 12V DC, as it uses TIP31 power transistor to handle load current. We can adjust the potentiometer VR1 to set […]