This article is about Simple Time Delay LED Circuit using Transistor where the LED lit after a short wait. The circuit needs transistor, capacitor and few resistors for delay. It is good for power light, warning light and timing project. It work with 10V DC and fits many electronics. Circuit Working: Parts List: Component Specification […]
Battery Operated Automatic Emergency Light Circuit
Automatic emergency light use battery and give light when power is gone. Lamp turns ON itself when main power fails and is good for home, office or anywhere which need extra light. It is best to use 6V lead acid battery or 5×1.2V NiCd cells. The design for Battery Operated Automatic Emergency Light Circuit is […]
Simple Relay Based Lamp Flasher Circuit
Simple Relay Based Lamp Flasher Circuit is good for indicators, warning lights and in anything that need attention. Circuit uses relay, resistor, capacitor to blink light and does not need any complex parts. It runs on 12V and is easy for beginners to learn electronics. Circuit Working: Parts List: Component Specification Quantity Resistor 220Ω 1W […]
Simple 12V Lamp Flasher Circuit using IC LM317
This Simple 12V Lamp Flasher Circuit using IC LM317 is a cool project to make 12V lamp blink. This circuit is not only for indicator or warning light but also for car or decoration light. IC LM317 usually controls the voltage but here it work like oscillator for blink. It can handle 1A, so lamp […]
Emergency Lamp Circuit using IC LM358
Simple but strong Emergency Lamp Circuit using IC LM358 is an easy to make project. Circuit is good for backup light when power goes OFF. Circuit gives automatic light during power cut. IC LM358 op-amp sense power fail and control the lamp. It needs 12V battery to run the circuit. Circuit Working: Parts List: Component […]
Simple 24V Lamp Flasher Circuit using Transistors
Simple 24V Lamp Flasher Circuit using Transistors makes 24V lamps blink back and forth with non stop. It uses transistors to turn two lamps ON and OFF one by one like astable multivibrator. This circuit is good for signal use like warning or decoration lights with steady blink. We must use 24V DC power to […]