When ON, small device like Simple Door Keyhole Light Circuit gives light to keyhole. It helps to put key in hole when light is low. It uses light sensor and circuit to check light level. To switch it by light we used transistor and LDR. Circuit Working: Parts List: Category Item Quantity Resistors 47k 1/4 […]
LED and Lamps
Home » LED and Lamps »
Simple Electronic Candle Circuit using LDR
This article for Simple Electronic Candle Circuit using LDR is fun and easy project to make fake candle with LED. It uses LDR to make LED flicker like real flame and turns ON when its dark. LDR controls the LED. In bright light the LDR has high resistance so LED stays OFF. And when its […]
Simple Motor Powered Emergency Flashlight Circuit
This is Simple Motor Powered Emergency Flashlight Circuit which is easy to make for emergency light. It uses motor like generator to make power. Power goes to LED for light and charges the supercapacitor. And then it turns motor to charge. Circuit Working: Parts List: Component Type Description Quantity Resistors 220Ω 1/4 watt 1 Semiconductors […]
12V SMPS Driver Circuit for LED Strip
12V SMPS driver change big AC power from 110V or 220V into small 12V DC. Circuit is good for LED strip light. In this DIY we make cheap and strong LED driver. It can power full 12V LED strip with 100 or 200 LEDs. Important points to follow: Circuit uses 230V AC direct which is […]
Simple Flasher Circuit using LED and LDR
LED and LDR are used to make this easy and Simple Flasher Circuit. LDR changes resistance when light changes and this control LED blink. There is no need for big chips or transistors but still the LED blink happens. It uses simple parts like resistor, capacitor and special light sensor called LDR. Circuit Working: Parts […]
Automatic Staircase Light Circuit
Automatic Staircase Light Circuit turn ON light when someone uses stairs. After some time it turn OFF by itself automatically. It help keep home safe and saves electricity. Circuit Introduction: Regular stair lights: Need to turn ON/OFF by hand using switches at top and bottom. Sometimes people forget to turn OFF, so energy gets wasted. […]