Simple FM Microphone Transmitter Circuit

FM mic transmitter is small device.

It changes sound from mic into radio signal.

FM radio can hear it in short distance.

This Simple FM Microphone Transmitter Circuit uses one NPN BC547 transistor.

Even it is small it can send FM signal pretty far.

Circuit Working:

Parts List:

This FM transmitter circuit take voice from small mic means condenser mic.

If we want to send direct audio then remove mic and give audio at base and R1 point.

To make signal go more far then use long wire or antenna.

Trim capacitor C2 and coil L1 set the FM signal frequency and always use free non-commercial FM band.

With this simple FM transmitter we can send sound on FM radio.

Easy points about this circuit:

One Transistor Only:

It is for very simple use only with one transistor.

Changeable Frequency:

By adjusting C1 and L1 we can change frequency from 50MHz to 160MHz where FM radio can catch it.

Mic Input:

Mic take sound and circuit makes signal.

Low Power Use:

Use small battery power with only few parts inside.

Not as strong or clear as advanced circuits but is good for beginners to learn FM transmitter basics.

Formulas:

We can find the exact working frequency of FM transmitter using this formula:

f = 1 / (2π√(L * C))

where:

• f is frequency in hertz Hz
• L is coil value in henrys H
• C is capacitor value in farads F

Note:

This formula works for perfect circuit.

In real life small extra things like wire effects or part changes can change result a bit.

Trimmer capacitor C2 is used to set frequency inside FM range with 88 MHz to 108 MHz.

Better to use full circuit diagram with all part values and tips for tuning when building FM mic transmitter.

How to Build:

To build a Simple FM Microphone Transmitter Circuit follow the below mentioned steps for connections:

• Gather all parts like in circuit diagram.
• Connect collector of transistor Q1 to +9V battery through coil L1.
• Connect base of Q1 to (+) side of electret mic.
• Connect (–) side of mic to ground.
• Connect emitter of Q1 to ground through resistor R2.
• Connect R1 and C1 from +9V to ground.
• Connect capacitor C2 between +9V and collector of Q1.
• Attach antenna after C2.
• Also connect C2 between collector of Q1 and point between emitter and R2.

Important Notes:

• FM mic transmitters must follow our countries radio rules.
• We must use only allowed power and frequency.
• Ask the local radio department for legal information.

Conclusion:

This Simple FM Microphone Transmitter Circuit is great for learning how FM signals work.

But always be safe and follow the local radio laws.

References:

FM Microphone Transmitter Circuit