Simple Hulda Clark Zapper Circuit using IC 555

Simple Hulda Clark Zapper Circuit using IC 555 make electric current with set frequency for healing.

It uses IC 555 chip.

This type of circuit are also called Hulda Clark zapper which was made in 2003.

Circuit Working:

Parts List:

Many doctors say Hulda Clarks zapper claims are not true.

There is no science proof that zapper can heal or cure sickness.

Using zapper can may be unsafe and cause health problems.

But if still anyone want to try the circuit here is how it works:

Circuit uses 9V battery to power it.

IC 555 works as astable multivibrator which means it gives square wave output again and again.

Parts like capacitor C1 and resistor R2 decide the signal frequency with around tens of kHz.

Capacitor C2 and resistor R3 help remove glitches means debounce in the signal.

Resistor R1 and red LED show power is ON.

Copper tubes act like electrodes and when user holds them the square wave signal goes into the body.

Important:

Always talk to doctor before using zapper it can be risky and science does not support its healing claims.

Formulas:

We use IC 555 to make an astable multivibrator for Hulda Clark Zapper.

Goal is to get square wave with correct frequency and duty cycle.

Formula for Frequency (f):

f = 1.44 / (R1 + 2×R2) × C

• R1 and R2 are resistors
• C is timing capacitor

Duty Cycle D:

D = R2 / (R1 + 2×R2)

Shows how long output stays ON compared to OFF

To get right frequency and duty cycle we need change R1, R2 and C values.

Reminder: Always be careful with electronic therapy and check proper safety rules before using it.

How to Build:

To build a Simple Hulda Clark Zapper Circuit follow the below mentioned steps for connections:

• Connect pin 1 of IC 555 to ground.
• Connect pin 2 to pin 6 of IC 555.
• Connect capacitor C1 between pin 2 & 6 and ground.
• Connect pin 3 output to one copper tube through resistor R4 and connect the other copper tube to ground.
• Connect pin 4 to positive supply of 9V.
• Connect pin 5 to capacitor C2 and the other side of C2 to ground.
• Place resistor R3 between pin 6 and pin 7.
• Connect resistor R2 from pin 7 to positive supply of 9V.
• Connect pin 8 to positive supply of 9V.
• From pin 3 connect a resistor R1 and red LED in series to ground to show power status.

Important Note:

• As said before there is no scientific proof that zappers can heal or treat diseases.
• Doctors and medical experts warn against using zappers because they may cause health problems.
• Always talk to a doctor before trying or using any zapper circuit.

Conclusion:

We can build and easy and Simple Hulda Clark Zapper Circuit using IC 555.

But remember there is no real evidence of health benefits.

Due to safety risks medical authorities recommend not using these devices.

But if anyone is thinking about using a zapper then see a doctor first.

References:

Hulda Regehr Clark