Want to light an LED using a battery? then this Simple LED Circuit using 9V Battery shows how; as it is the first step to learn electronics and current flow.
In addition, just with one battery, one resistor and one LED, we can make it in few minutes and see our LED glow bright.
Circuit Working:
Parts List:
The 9V battery gives power to LED through a resistor and moreover, LED lights only when current flows in correct direction.
Then resistor controls the current going to LED and without resistor a LED will burn because current is too high.
Formula with Calculation:
The formula for Simple LED Circuit.
Battery voltage = 9V
LED voltage drop = 2V (red LED)
Required current for LED = 20mA = 0.02A
Voltage drop across resistor = 9 – 2 = 7V
Resistor value R = V / I = 7 / 0.02 = 350 ohms
So we used R1 = 350Ω resistor.
How to Build:
To build a Simple LED Circuit follow the below steps:
- First, gather all the parts as in circuit diagram.
- Next, connect positive (+) terminal of 9V battery to one end of resistor R1 and connect other end of resistor to LED anode.
- Then connect LED cathode to negative (-) terminal of battery.
Conclusion:
To conclude, this Simple LED Circuit is very easy to make, as it helps beginners to learn about LED polarity and resistor use; therefore always use resistor to protect LED from high current.