AC to DC Bridge Voltage Doubler Power Supply Circuit

AC to DC Bridge Voltage Doubler is simple power supply circuit.

It is used to get higher DC voltage from low AC voltage, for example from 9V AC we can get near 18V to 25V DC.

Therefore, it is useful when we need high voltage but transformer gives low voltage.

Also, this circuit is with low cost and easy to build.

Circuit Working:

Components	Specification	Quantity
Capacitors	Electrolytic 470uF 63V	2
Semiconductors	Transformer 0V-9V AC secondary, 220V primary	1
	Bridge diodes 1N4007	4

The above circuit uses a step down transformer 220V AC to 9V AC, four bridge diodes and two electrolytic capacitors.

First, 220V AC mains goes to transformer primary and this transformer reduces voltage to 9V AC at secondary.

Then 9V AC goes to bridge network made by four diodes and this bridge works like rectifier and voltage doubler together.

C1 and C2 are filter capacitors and they charge on alternate half cycles, after that their voltages add in series.

Therefore, output voltage becomes nearly double of AC peak voltage and finally we get DC output across Vout and GND.

First find peak voltage from AC RMS voltage.

Vpeak = Vrms x 1.414

If transformer secondary is 9V AC then:

Vpeak = 9 x 1.414

Vpeak = 12.726V

Now voltage doubler output is approximately:

Vout = 2 x Vpeak

So,

Vout = 2 x 12.726

Vout = 25.452V

Now subtract diode drops, as each diode drop is about 0.7V (silicon diode) and two diodes conduct in each half cycle.

Total diode drop = 0.7 x 2

Total diode drop = 1.4V

So practical DC output is:

Vout practical = 25.452 – 1.4 = 24V

Vout practical approximately is 24V but under load the voltage may reduce more.

To build a AC to DC Bridge Voltage Doubler Power Supply Circuit follow the below connection steps:

First, gather all the circuit parts as shown in diagram above.
Transformer primary side connect 220V AC mains to primary pins carefully.
Secondary side one pin goes to bridge diode input point and second pin goes to 0V.
Diodes D1 to D4 connect as per circuit diagram.
Capacitors C1 positive side connect to to positive output and negative of C1 connect to .
Connect positive of C2 to 0V and negative of C2 goes to -V.

AC to DC Bridge Voltage Doubler Power Supply Circuit is simple and useful project.

It increases DC voltage without using high voltage transformer.

Therefore, it saves cost and space, however it is good only for low current applications.

If load current is high then voltage drop will be more.

So use this circuit for small current power supply needs like small projects and experiments.