Darkness Activated LED Circuit

This article explains about a Darkness Activated LED Circuit which is useful device that saves power.

It is energy efficient circuit because light glows only in darkness.

The circuit turns ON light at night and it turns OFF light in day time.

It works fully automatic so, no manual switch is needed daily.

It is simple circuit with low cost and is good for home, garden and pathways.

Circuit Working:

Parts List:

At start first, the supply is given using battery.

Switch S1 is turned ON and through this circuit becomes active.

During day time the light falls on LDR and so LDR resistance becomes low.

Because of this the base voltage of Q1 is low and therefore, Q1 remains OFF.

Then Q2 also remains OFF and so LEDs do not glow, but at night time no light falls on LDR.

So, LDR resistance becomes high and then voltage at base of Q1 increases.

Because of this Q1 turns ON and after that Q2 also turns ON.

Now current flows through LEDs and so LEDs glow automatically.

Thus, light turns ON in dark and it turns OFF in bright light.

How to Build:

To build a Darkness Activated LED Circuit follow the below connection steps:

• First, gather all the part as shown in circuit diagram.
• LDR one end goes to R1 and R2 junction
• And other end goes to ground
• R1 100k one end connects to supply positive
• And other end to LDR one end.
• R2 10k one end goes to LDR and R1 junction
• And other end goes to base of Q1
• Q1 BC547 emitter pin connects to base of Q2.
• Base pin connects to R2
• Collector connects to collector of Q2 and LEDs junction.
• Q2 BC337 Base pin goes from emitter of Q1
• Emitter pin goes to ground
• Collector goes to negative side of LED group
• LEDs anodes are connected together to one end of resistor R3.
• Cathodes are connected together to collector of Q2 and Q1
• Battery positive goes to switch S1 and battery negative to ground.

Conclusion:

This Darkness Activated LED Circuit is very simple and is easy to build.

It uses parts which are easily available, as it takes very low power and it works properly all the time.

So, beginners can make this circuit easily which is also useful for real use.

Finally, this circuit is a good choice and is best for automatic light ON and OFF.

References:

Can this work as a dark-activated light circuit?