Simple Battery Eliminator Circuit using IC LM317

Simple Battery Eliminator Circuit using IC LM317 gives steady DC power with no need of normal battery.

It is good for small devices needing stable voltage.

This article show how to make simple battery eliminator using LM317 IC.

We also can show circuit to replace 9V battery.

It can be used for any device which need 9V battery.

Circuit Working:

Parts List:

Transformer take 230V AC and change to 9V AC.

Then bridge rectifier with 4 diodes 1A each change AC to pulsating DC.

Capacitor C1 10μF filter this DC to make it better.

This DC goes to LM317 IC and give steady and adjustable voltage.

Output voltage depend on resistors R1 and R3.

Another capacitor C2 10μF at output makes voltage more smooth and reduces the ripples.

Formulas:

Formula for LM317 Output Voltage:

Vout = Vref × (1 + R2 / R1)

where,

• Vref is 1.25V Iadj which is very small and can be skip

How to Build:

To build a Simple Battery Eliminator Circuit using IC LM317 follow the below mentioned steps:

• Gather all the parts as shown in circuit diagram
• Connect (+) of C1 to input pin of IC1 and (–) of C1 to GND.
• Connect ADJ pin of IC1 to one side of R1 and other side of R1 to GND.
• ADJ pin also connect between R2 and R3.
• Output pin of IC1 go to (+) of 9V DC and (–) goes to GND.
• R2 and R3 connect from output pin to GND.
• positive of C2 connect to output pin of IC1 and negative of C2 connect to GND.
• Connect bridge rectifier one pin to input of IC1 and other pin to GND
• Third and fourth pins go to two wires of 9V transformer

Conclusion:

This Simple Battery Eliminator Circuit using IC LM317 gives stable DC voltage.

It is good for electronics where battery is not needed.

IC LM317 keeps voltage steady.

This circuit is easy and simple and is best for beginners and hobby lovers.

References:

LM317 3-Terminal Adjustable Regulator