Simple Static Electricity Detector Circuit

Simple Static Electricity Detector Circuit is like alarm for electricity when gathers on things like clothes.

This happen when we rub things together.

This kind of electricity can break small electronics so detector is useful near them.

Detector have special sensor which feels electric change in air.

Maybe its wire stick out or maybe flat plate.

When it feel static it turns ON light or make sound and say “Hey! Electricity here!”

Circuit Working:

Parts List:

In this article we have used JFET T1 2N3819 to catch static electric touch.

The connections of the circuit components are as follows::

Gate connect to 1 meter wire antenna with 1M resistor called R1.

Source connects to ground using 470 ohm resistor called R2.

One LED is included between JFET drain and plus side of battery.

Whole circuit get power from 9V battery.

When antenna feel static charge JFET make signal bigger and LED lights up to show it have caught something.

Formulas and Calculations:

We can make easy circuit using JFET 2N3819 to find static electricity.

Just use parts like mentioned in the diagram above and build static detector.

Main idea is simple JFET work like amplifier with high resistance and it catches very small voltage change from static.

Then LED light up to show static is there.

LED Current:

When static is found LED get current like this:

I_LED​ = ​V_Battery​−V_LED​​ / R_LED

where,

• Battery is 9V
• LED drop is 2V
• Resistor is 470 ohm

Therefore:

ILED = 9V − 2V / 470Ω = 14.9mA

This current is enough to turn LED ON.

This simple static finder is good for many jobs for testing static, showing static in class and more.

It is easy to make but still works very well!

How to Build:

To build a Simple Static Electricity Detector Circuit we needs to follow the below mentioned assembling steps:

• Take gate of JFET and connect it to one side of 1M resistor R1.
• Other side of that resistor connects to 1 meter long antenna.
• Now connect source pin of JFET to one side of 470 ohm resistor R2.
• Other side of R2 connects to ground.
• Drain of JFET connect to positive leg anode of LED.
• Negative leg cathode of LED connect to plus (+) side of 9V battery.
• Minus (−) side of battery connects to ground.

Note:

• Be sure all wires are tight and parts are in right place.
• When antenna feel static, JFET make signal strong and LED will turn ON to show it.

Conclusion:

Simple Static Electricity Detector Circuit is useful tool.

It helps to find and show static charge which can hurt small electronic parts.

By using sensor and making signal bigger this circuit help keep electronics safe from static shock.

It ensures they work good and last for long time.

References:

Darlington triplet – static electricity detector?

Static electricity