Simple 1.5V White LED Flasher Circuit

This Simple 1.5V White LED Flasher Circuit uses few parts to make white LED blink ON and OFF again and again.

It is an easy project and is good for beginners.

Fun to play with blinking light with no need with hard design.

Circuit Working:

Parts List:

This is 1.5V white LED flasher circuit and it uses transistor to make LED blink.

How it work:

Turn switch ON and current goes from battery through resistor R1 and to base of transistor Q1.

Q1 turn ON and current goes through Q1 and inductor.

Inductor build magnetic field when current flow.

Small coil uses ferrite core with size 2.6mm wide and 6mm long.

Turn switch OFF and current stops.

Inductor make voltage spike because it does not like change.

Spike goes to base of Q2 by capacitor C1 and diode 1N4148.

Q2 turns ON and current goes through LED and LED flashes.

Capacitor C2 control how fast LED blink.

Parts value change blink speed and try different values for fun.

Important:

Be sure transistors and LED are okay with voltage and current.

Check component direction especially LED and diode.

Use breadboard to test before solder.

Formulas:

This circuit uses low power with only 1.5V which is good for battery use.

LED flasher frequency:

Blink speed frequency depends on R1 and C1.

Formula:

f = 1 / (2.2 × R1 × C1)

• R1 is the resistance in ohms
• C1 is the capacitance in farads

Capacitor reactance (XC):

Capacitor C2 also affect feedback and stability.

Formula:

XC = 1 / (2π × f × C2)

• C2 is the capacitance in farads
• f is the frequency

Understand these things to build and change LED flasher circuit better.

Be sure oscillator set is correct and transistor work well.

And capacitor and inductor give proper feedback.

How to Build:

To build a Simple 1.5V White LED Flasher Circuit follow the below mentioned steps for connections:

• Q1 collector connects to positive supply
• Q1 base connects to ferrite coil and resistor R1
• Q1 emitter connects to ground
• Q2 collector connects to ground through white LED and resistor R3
• Q2 base is not connected (NC)
• Q2 emitter connects positive supply through resistor R2
• Capacitor C2 connects from Q2 emitter to ground
• Diode 1N4148 connects from ferrite coil to positive supply
• ON/OFF switch connects positive of 1.5V battery

Note:

• Be careful as this circuits can give shock.

Conclusion:

This Simple 1.5V White LED Flasher Circuit is fun and is good for learning.

It uses only 1 AA battery.

Even with low voltage it can flash LED.

This circuit is easy to make and is good for low power use.

References:

Ultra low power/ simple flashing circuit